If you want to build your own cabinet bench, the DCT | 10-Inch Front Bench Vise Wood Bench Clamp is a face vise that has all of the essential working hardware needed for a strong, large-capacity bench vise. To install, simply align flush to the edge of the bench and screw down the vise with lag bolts or screws (not included). The center screw keeps the material close to the screw, which minimizes racking or skewing. This woodworker bench vise screw offers smooth performance and features a large lead screw to allow for quick adjustments (not quick release). 7/8-inch dowel handle recommended – it is advantageous for the handle to slide back and forth. Jaw, handle, and mounting hardware required, not included. Length of screws and width of jaws depend on your bench. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Product Features

• CREATE A WOOD VISE FOR WORKBENCH: The DCT | 10-Inch Wood Bench Vise is a woodworkers vise for workbench that allows you to make a strong, large-capacity bench vise when building your own cabinet bench; Simply add your own wooden jaw (and jaw stop, optional), wooden handle (7/8-inch to 1-inch diameter dial rod or dowel recommended), and mounting hardware for 1/3-inch (8mm) diameter screw holes (length of screws depends on your material limits)
• LESS RACKING, MORE PRODUCTIVITY: Success with using this wood working vise depends on the bench you are mounting to and material used for the vise chop; The center screw is designed to keep the material close to the screw, which minimizes racking or skewing; Further lessen racking by adding a spacer (or piece of scrap) the same thickness as the work piece placed on the opposite side or by moving your work piece closer to the screw
• ADJUST QUICKLY: Large lead screw allows quick adjustments; 10-inch screw length x 1-inch screw diameter (25.4cm x 2.5cm); 18″ x 7″ x 1.6″ inch (45.7cm x 17.8cm x 4.1cm) overall dimensions; 0.6-inch (4.1cm) diameter tracking guide rod supports that stand 6 inches (15.2cm) apart (measured center to center; 5.5 inches / 14cm apart from sides); With the size of the screw, consequently, the thread size, it eliminates the need for a quick release mechanism (unit is manual release, not quick release)
• EASY TO USE: 2-inch (5.1cm) clearance required; With a pencil, mark hole locations for guide rods and vise screw (or create a cardboard template), then bore holes larger than diameters of guide rods and vise screw to eliminate binding when wood expands; Fit handle assembly into vise, push guide rods and vise screw through vise face, and position in center of their holes, secure handle plate to outside of vise face with screws or bolts (not included); Screw vise plate against underside of bench
• BUILT TO LAST: End vise woodworking vise screw constructed from heavy-duty cast-iron and steel for ultimate strength and longevity; Jaw (and jaw stop), handle, and mounting hardware not included in this tail vise woodworking vises package